Using the projector in Cordley 3003
- Turn the presentation computer on.
- Using the switch located to the left of the chalk board, lower the projection screen.
Pressing the switch down lowers the screen.
- Press the power button located on the bottom of the projector ONCE.
You will hear the fans on the projector turn on. After a few seconds the Infocus screen will show up on the screen.
- Press the “computer” button ONCE to change the video input, also located on the bottom of the projector.
A message will appear on the lower right corner of the projection screen that says, “computer 2, perfecting image, please wait.”
- Should the image on the projection screen be off center you can adjust it using the horizontal shift knob located below the projection screen switch.
Turning the knob, marked H. Shift clockwise moves the projection right. Turning the knob counterclockwise moves the projection to the left.
- The sign located on the computer cart, “Class in session,” should be put onto the outside of the door of the classroom.
- When you are through with your presentation press the power button on the bottom of the projector ONCE.
You will see a message that says, “powering down” on the lower right corner of the projection screen. If for some reason you need to turn the projector back on, wait a few minutes before doing so. This will allow the bulbs to cool down.
- Using the switch located to the left of the chalkboard please raise the projection screen.
- Remove the sign from the outside of the classroom door and put it back onto the computer cart.
